Technical Spec. User-Friendly Features Easy access front loading battery door. Battery backup provides protection in case of power failure.
Interconnectable with up to 24 devices of which 18 can be initiating including smoke, CO and heat alarms. Do hardwired smoke detectors need to be replaced? Pros recommend changing hard-wired smoke alarms after 10 years.
Dear Michael: Your alarms are overdue for replacement, according to the National Fire Protection Association, which recommends that you replace a detector when it's 10 years old. Will fire department check smoke detectors? How do I know if my smoke detector needs a new battery? Press and hold the test button on the smoke detector.
It can take a few seconds to begin, but a loud, ear-piercing siren should emanate from the smoke detector while the button is pressed. If the sound is weak or nonexistent, replace your batteries. Do you really need to replace smoke detectors every 10 years?
Smoke alarm lifespans can vary, but according to the association, smoke alarms need to be replaced at least every 10 years. According to Carli, that lack of awareness means some U.
When did they start putting dates on smoke detectors? The first national standard for smoke detectors, now more commonly referred to as smoke alarms emerged in How do you test an interconnected smoke detector? Read on for information about ionization detectors.
Ionization-Based Smoke Detectors : Ionization detectors contain a small amount of Americium , a radioactive isotope. Rip off a piece of aluminum foil to fit over the smoke detector and around its sides. Wrap the piece of aluminum foil around the smoke detector. It should stay by itself, but if it doesn't, wrap a large rubber band around it. If there are connecting wires, it is a hard - wired unit and the wires can be disconnected.
Dismount from the ladder and flip the circuit breaker switch that controls the smoke detector. If there is no obvious marking on the panel that designates a switch for the detector , throw the main breaker to the "Off" position. Battery -powered smoke alarms are easier to install. While more work is required to install them, hardwired smoke alarms can be interconnected, meaning if one smoke alarm is activated, it will engage all other alarms in your home.
To find out how old your smoke alarm is and its expiration date , simply look on the back of the alarm where the date of manufacture is marked. The smoke alarm should be replaced 10 years from that date not the date of purchase. But nearly all smoke detectors , including those that run on household current, do contain a battery.
Detectors that are hard - wired to the home's electrical system use this battery to provide backup power in case a fire knocks out the house's electrical power. It likely has to do with the lifetime of the hardware itself. Remember, there's a circuit board and a light source, as well as a detector. Those don't last forever. So the manufacturer certifies the device will work for only 10 years , and then in some modern units sets a hard sunset by using an unreplacable battery.
The flashing red light gives a visual indication that the smoke alarm is functioning properly. As the dust accumulates in the detecting chamber, the sensitivity will increase causing the frequency of nuisance alarms to increase as well. Smoke alarms in these environments will have to be cleaned more often. To clean your alarms, remove them from the wall or ceiling and hold the unit on its side. This needs to be thoroughly cleaned since there is dust or debris caught in the sensor.
This should fix the problem. Question: Why does the alarm go off during cold weather? Answer: The unit may go into alarm only when it is very cold out or if a door adjacent to a heated area is opened, such as in an entry way. This is due to condensation water vapor in the detection chamber.
The sensor is a particle-sensing device and when water condenses in the sensor, the unit will go into alarm. The operating temperature on FireX smoke alarms is between 40 and degrees Fahrenheit 4 - 38 degrees Celsius. If the unit is in a garage or attic, you may consider replacing it with a heat alarm which is not effected by condensation.
Question: How often should the battery be changed in my smoke alarm? Answer: It is recommended that the battery in every smoke alarm be replaced at least once a year to ensure it is operating properly or any time the unit indicates that the battery is weak. When the battery requires replacement, the alarm will sound a short beep or chirp approximately once every minute. At this time you must remove the old battery and replace it with a fresh battery of the correct type.
Question: What is the warranty on FireX smoke alarms and how do I get it repaired or replaced? Answer: If any smoke alarm does not sound when the test button is pressed, it should be replaced immediately. FireX smoke alarms include a 5 year warranty.
If the unit fails while under warranty, return it to:. Mebane NC A replacement unit will be sent to you. Answer: The TEST button must be held for at least 3 seconds before the unit will begin its test sounding. If the smoke alarm does not go into alarm and it is an AC unit, replace it immediately. If the unit is a battery-powered unit and it does not sound, it may have a weak battery.
If the unit does not sound with a fresh battery or there is any concern or question about the reliability of the unit, it should be replaced. FireX smoke alarms have a 5-year warranty. The manufactured date is stamped on the label located on the back of the unit. If the is under warranty, send it to the following address:. Please include your address for shipping and a brief description of the problem.
0コメント